Timing Belt Maintenance Is Important

Timing Belt:

(1) Turn off the power, remove the protective cover, and loosen the mounting bolts of the motor. The mobile motor makes the belt loose enough to remove the belt without prying, and do not pry the belt.

(2) Remove the old belt and check for any abnormal wear. Excessive wear may mean that there is a problem with the design or maintenance of the drive.

(3) Select the appropriate belt replacement.

(4) clean the belt and pulley, wiping the cloth should be a little easy to wipe the liquid, in the detergent soak or use detergent to wash the belt are not desirable; to remove oil and dirt, with sandpaper or with sharp Object scraping, obviously not desirable. The belt must be kept dry before installation.

(5) check the pulley for abnormal wear or crack, if the wear and tear, you must replace the pulley.

(6) Check whether the pulley is linearly symmetrical. The pulley is linearly symmetrical with respect to the operation of the belt, especially the synchronous belt drive.

(7) Check the rest of the transmission components, such as bearing and sleeve symmetry, durability and lubrication.

(8) to install a new belt on the pulley, never pry or force too much.

(9) Tighten the center of the drive until the tension gauge measures the belt tension as appropriate. Turn the wheel by hand and retract the tension.

(10) Tighten the motor assembly bolts to correct the torque. Since any change in the center distance of the drive during operation will result in poor belt performance, it is important to ensure that all drive parts are tightened.

(11) start the device and observe the belt performance, see if there is abnormal vibration, listen to whether there is abnormal noise. It is best to turn off the machine, check the bearing and motor conditions; if it feels too hot, may be too tight belt or bearing asymmetry, or lubrication is not correct.

Timing belt maintenance

(1) The belt should not be twisted and drastically bent, with the minimum bending diameter of the belt.

(2) in the storage and transportation process, to avoid direct sunlight, rain and snow leaching; to prevent acid, alkali, organic solvents, water vapor and other products affect the performance of material contact;

(3) at room temperature storage, the general temperature is

And at least one meter away from the heat source.

(4) during storage to prevent excessive weight and deformation, shall not be stacked pressure, shall not be directly on the ground, should be hanging on the shelf or flat on the shelves.

(5) The finished product shall be stored and transported in a dry and ventilated environment, and the finished product shall be treated with rust;

(6) with the transmission device should be added protective cover, and to ensure ventilation and sewage.