Timing belt installation

1. Align the mark of the camshaft timing gear with the mark on the valve cover

2. Align the crankshaft timing gear mark with the front cover mark.

Third, the timing belt is sequentially installed as the crankshaft timing gear pump pulley idler camshaft timing gear and pulley pulley

4. Loosen the pulley mounting bolt 1/4—1/2 turn and compress the automatic tensioner push rod to the lowest position. Use steel to insert the hole. Use the snap ring clamp to adjust the pulley counterclockwise to make the two adjustment holes parallel to the ground. Lock the fixing bolt and pull out the steel needle

5. Rotate the crankshaft 2 times clockwise to check if the timing mark is correctly aligned.

Sixth, turn back to the engine right nail timing belt outside the lower cover timing belt outer cover

Seven, replace the generator air conditioner compressor belt

Eight, check the engine for abnormalities but need to pay attention, different models are different, I hope to pay attention.

201608301119306160398